Briketna stiskalnica / briketna stiskalnica

mütek Systemtechnik MPP 110

Production time for the machine approx. 3.5 months

Very robust machine with high pressing force
- Also suitable for already producing a saleable briquette quality, depending on the material. The large-dimensioned press cylinder and the 65 mm briquette diameter make this possible.

Hnedpfxeffh Ats Abnor
Our best-selling briquetting press series
+ Proven, simple technology for extremely low susceptibility to faults
+ 25 years of experience, ongoing development and expertise
+ Several thousand machines in use with satisfied customers
+ Good price-performance ratio

Options:

Surcharge for cooling unit + €3,995 net (can also be retrofitted)
* cools the pressing tongs (important from 3.5 hours of operation) and the hydraulic oil
* Cooling unit recommended for regular operation of more than 3.5 hours at a stretch.

Large pre-compactor chamber + €1,975 net
Recommended for lightweight input materials such as planing shavings

Customs tariff number: 84793010
Briquette diameter: 65 mm
Front bushing: 65 mm
Max. briquette stroke: 50 mm
Optimal briquette stroke: 50 mm
Capacity (depending on material): up to 110 kg/h*
Last test: approx. 87 kg/h
*Depending on bulk density
*Based on a bulk density of 200 kg per cubic meter
.
Motor power: 5.5 kW
400 Volt / 50 Hz / 3-phase
Length: 1,925 mm
Width: 1,100 mm
Height: 1,500 mm
Weight: 800 kg
Oil volume: 110 liters
Silo diameter: 1,000 mm
Silo capacity: approx. 0.7 m³
Pump: 37 liters
Hydraulic pre-compactor
Press tong cooling option: yes, with special accessory of coolable press tongs
Cooling of the press tongs via a water tank (must be supplied by the customer)
Hydraulic oil cooling option: yes
Fill level monitoring option: yes
Continuous briquette option: yes (material-dependent)
CE compliant
.
Requirements for the raw material:
- The moisture content (oven dry basis) must be at least 6% and no more than 18%
- Maximum chip length: 15 mm
- Installation temperature: heated room of at least +5°C
- The feed material must be free of metal and mineral contaminants such as sand, stones, etc. Damage to the pressing tools and/or increased wear may result

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.