Zaposlitveni material Briketirna stiskalnica

mütek MAP 750

Used, good condition.
Technically inspected second-hand machine

Base machine starting from: €139,750 net
*Options available at extra cost, see below
Delivery time approx. 16 weeks after order

Briquetting press, e.g. for wood dust, spelt husks, enrichment material (such as toys and chewing material for pigs), animal feed, alfalfa, or wood shavings. *Optionally, short briquette tablets can be produced

Technical data:
Throughput capacity up to max. 750 kg/h (depending on material)
(e.g., sawdust with a bulk density of 250 kg/m³)
Accurate statements on throughput are only possible after testing with your material. Actual output may vary significantly depending on the bulk density of the starting material.

Customs tariff number: 84793010
Briquette Ø 65 mm
Including 2 m press channel
Main motor power: 37 kW
Feed screw geared motor: 2.2 kW
Compression screw: 5.5 kW
Hydraulic pump motor: 0.37 kW
Total connected load: approx. 47 kW
Control panel with plain text display for operating status
and load display for main drive and feed screws
PLC control with hour counter in the switch cabinet
Machine has CE marking
Automatic start-stop function
Dimensions 3100x860x1800 mm (LxWxH)
Weight: 3800 kg

Optional extras at additional cost:

Cgjdpfx Aefmqq Eshxst
Temperature control unit for press tools
To maintain temperature for optimum briquette quality. Includes temperature controller for pump, cooling unit, fan, pressure switch.
Pre-wired, ready to connect – mandatory for operation
Including corresponding control system + €7,850 net

Guillotine or tablet breaker
For cutting briquettes + €6,900 net
Compressed air connection required!

Silo for MAP series + €19,940 net
- Storage silo above the machine -
Capacity approx. 6 m³, robust steel construction with agitator discharge and level sensor.

Conveyor line/cooling section (nominal: 4x2m)
Each 2 meters €990 net

Installation/commissioning (estimated 2-3 days onsite)
Billed based on effort and separate calculation. The following rates apply:
Service technician/mechatronics per assembly and travel hour: €129.00
Overtime: 25% surcharge
Each Saturday/night hour: 50% surcharge
Each Sunday/holiday hour: 100% surcharge
Daily allowance per technician: depending on country
Per car/van and travel kilometer: €0.98/km
Travel and accommodation charged to client according to receipts or via flat rate.

Test run with customer-specific material: (by arrangement, up to a maximum of 750 kg) – €1,970 net flat rate

Raw material requirements:
- Moisture content (atro) must be between a minimum of 6% and maximum of 15%
- Chip length maximum 18 mm
- Installation temperature: heated room at minimum +5°C
- Feed material must be free from metals and mineral contamination. Damage to the press tools and/or increased wear may result

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.