CNC obdelovalni center

Holzfraese HP 1890

Used machine

Year of manufacture: 2019

Only 110 operating hours!

Features and technical data:

X = 1800 mm
Isdjw Nadyjpfx Ah Djbc
Y = 900 mm
Z = 80 mm

Constructed from 18 mm Koskisen panels, comprising a milling table (X-axis), a gantry (Y-axis), and a Z-axis.

Milling bed made of 19 mm MDF as a sacrificial plate with guide rails and T-slot nuts for clamping.

Base frame with struts, filled with polymer concrete, prepared for transport by pallet jack or forklift.

Mechanical set consisting of profile guides including carriages, as well as ball screws 2010 and 1605 for all axes.

Shaft couplings and high-performance grease for lubricating the individual carriages, as well as energy chains including connection sets.

Control set consisting of a Triple Beast controller for three axes, with Ethernet connection.

Leadshine driver for the fourth motor. Four stepper motors, 5.0A, 3Nm, with motor cables, as well as a 48V, 6.7A switching power supply, LED board for breakout board, ribbon cables and proximity sensors, as well as accessories such as wire leads, ferrules, control cables, heat shrink tubing, and cable lugs.

Fully installed in an aluminum housing, including electrical kit and emergency stop.

21.5 inch built-in monitor, including mini PC with Windows 7, CAD software Rhino 5.0, G-code generator Estlcam, control software Beamicon2, and mouse and keyboard, pre-installed in an ergonomic console.

Tool length sensor for determining length and updating the active zero offset.

Special features:

High-frequency spindle with 2.2 kW, including lock nut, frequency inverter, line filter, braking resistor, and collet set.

PC with 8 GB RAM and AMD processor

CAD software Rhino 5.0 for creating both simple 2D data and 3D solids

Availability: short-term
Location: Flörsheim

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.