Mizarstvo

Krüsi CM40

KRÜSI Chalet Construction Machine / Log House Production Line Type CM 40
Year of manufacture: 1996

Krüsi CM40, consisting of the following components:

Tjdpfxjvfv Tfj Altsa
- Circular saw (cross-cut saw)
- Log home milling unit, horizontal and vertical
- Groove milling (horizontal)
- Boring unit
- Infeed table 6 m
- Outfeed table 6 m

KRÜSI Chalet Construction Machine / Log House Production Line Type CM 40

Manufacturer: Krüsi Maschinenbau AG, CH-9105 Schönengrund AR
Year of manufacture: 1996
CE marked

Condition: Good, technically inspected and cleaned / ready for operation

Operating Principle:
Processing of timber for chalet / log house construction.
Beams can be processed in a single pass
- Cross-cutting
- Horizontal and vertical milling of tenons/grooves in a single clamping
- Drilling
- Cutting the end grooves

Workpiece capacity:
- Maximum cutting height: 200 mm
- Maximum cutting width: 250 mm

Sturdy construction with welded frame.
Machine (horizontal and vertical milling units) equipped with 4 special milling motors,
with hardened and ground guideways for maximum machining precision.
Carriage guidance via dust-protected and preloaded ball-bearing rollers.

Working range up to 200 x 250 mm. Fully operational, with contactor control,
Motors protected by thermal relay.
Electrical equipment for 380 V, 50 Hz, with protective covers,
Central connection for customer-side chip extraction, with 2 eccentric clamps,
without milling tools (groovers).

With hydropneumatic horizontal and vertical feed, electrically controlled,
synchronized with the start of the milling motors.
Rapid traverse and feed rate steplessly adjustable. Fully wired and installed, including air maintenance unit.
Timbers thicker than 14 cm must be processed in two passes.

Machine Description / Equipped with:

1. Saw Unit:
Manual feed
Spindle adjustment with analogue scale
Saw blade Ø max. / bore-Ø: 400 / 30 mm
Carbide-tipped with chip depth limiter (synchronous operation)
Adjustable riving knife
Motor speed [min-1]: 2900
Power (kW): 2.2

2. CM Milling Unit (Log House Unit)
Hydropneumatic feed
Spindle adjustment with digital readout
Horizontal milling unit
Cutter Ø: 180 mm
Cutter width max.: 130 mm
For cutter widths above 60 mm, only alloy cutters with indexable inserts may be used
2 motors, hydropneumatic feed, 2.2 kW each
Feed: hydropneumatic
Rapid traverse and working feed steplessly adjustable

3. Drilling Unit:
Manual feed
Spindle adjustment with analogue scale
Drill holder: ER 25 collet
Clamping Ø max.: 16 mm
Drill Ø max.: 32 mm
Motor [min-1]: 1450, 1.8 kW

4. Planing Milling Unit:
Hydropneumatic feed
Spindle adjustment with digital readout
Cutter Ø max.: 230 mm
Cutter width max.: 60 mm
Motor [min-1]: 2900, 3.0 kW
2 V-belts SPZ 9.5x1000 La

Pneumatics
Operating pressure on site min/max MPa (bar): 0.7/1 (7/10)
Air consumption Nm3/h: 8

Electrical Equipment
Operating voltage V/Hz: 380, 50
Rated power (kW): 8.8 - 15.8 depending on version
Customer-side fuse protection: 3 x 25 A tr

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.