HBC 110 K / 75 kW

Bollegraaf Recycling Solutions B.V. HBC 100 K

For sale: Fully reconditioned baler with 100 t pressing force, large bale size 1100 x 1100 mm, 75 kW drive power, and 10-fold cross-tying.

Technical data – Baler:
Manufacturer: Bollegraaf
Model: HBC 110 K / 75 kW
Year of manufacture: 2007
Main ram pressing force: 100 t
Pre-pressing force: 50 t
Operating hours: 22,605 hours
Feed opening dimensions: 1,600 x 1,100 mm
Filling volume / press cycle: 3.15 m³
Theoretical cycle time: 19 seconds
Bale size: 1,100 x 1,100 mm
Drive power: 75 kW
Total connected load: 126 kW
Hnsdsvf E Avepfx Adkei
Total current draw: 238 A
Tying: 5-fold vertical, 5-fold horizontal, fully automatic
Throughput rates at a
bulk density of 30 kg/m³: approx. 16 t/hour
bulk density of 50 kg/m³: approx. 25 t/hour
bulk density of 100 kg/m³: approx. 47 t/hour
Bale weights up to 1,400 kg, depending on material and bale length
Hydraulic tank capacity: approx. 1,300 l
PLC control: Telemecanique TSX Micro
Operator panel: Schneider MAGELIS Touch
Installed baler dimensions with hopper: 11,750 x 5,000 x 7,105 mm (L x W x H)
Transport dimensions baler only: 11,765 x 2,500 x 3,450 mm (L x W x H)
Machine weight baler: approx. 36 t

Notes:
The baler was partially reconditioned, serviced, tested after completion, and stored in our workshop. The machine is available at short notice and can be inspected at our warehouse by appointment.

The following refurbishment work was performed:
- Removal of rust and partial repainting of the press
- Complete drainage of hydraulic oil tank, oil and air filters replaced
- New hydraulic oil filled
- All hydraulic hoses replaced
- Main hydraulic cylinder, two pre-press flap cylinders, and compression channel cylinder removed, disassembled, inspected, cylinder tubes honed, all seal kits replaced, and final pressure test conducted
- Pre-press flap disassembled with bearings and bearing blocks; first and third arc segments removed and rewelded
- Both shaft bearings on the pre-press flap replaced
- Upper material guide on pre-press flap frame replaced
- Press ram dismantled, inspected, and both front guide rollers replaced
- Material guides and wear plates on sides and base of press ram removed and rewelded
- Horizontal and vertical needle and tying units dismantled, disassembled, inspected; plastic slide plates, twister shaft bearings, and wire deflector pulleys with bearings in the needle heads replaced
- Both bronze slide rails left and right in the frame cover for the press ram replaced
- Both wire deflection units left and right, with bale retention clamps completely replaced
- Wire feed unit including hydraulic cylinder under needle passages completely renewed
- Wire feed tracks in the floor and sidewalls of the press channel welded up and smoothed
- General maintenance and servicing carried out according to manufacturer’s specifications
- Baler tested in manual and automatic mode after refurbishment, accepted, and stored

We accept no liability for the technical data or any potential errors.

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.