Balirna preša 80 t s posebnim stiskalnim okvirjem za zahtevne materiale

Avermann Maschinenfabrik GmbH & Co. KG AVOS 1410-45/80

Technical Data – Baler:

Manufacturer: Avermann Maschinenfabrik GmbH & Co. KG, Germany
Model: AVOS 1410-45/80
Year of manufacture: 2009
Operating hours: 22,029 hours as of December 2025
Pressing force: 80 kN
Specific pressing force: 103.9 N/cm²
Filling chute dimensions: 1,400 x 1,000 mm
Theoretical cycle time: 12 seconds
Theoretical throughput: 300 m³/hour
Bale dimensions: 1,100 x 750 mm (W x H), length variable
Drive power: 45 kW
Total connected load: 75 kW
Tying: 4-fold vertical, fully automatic
Throughput (at bulk densities):
– 30 kg/m³: approx. 6.0 t/hour
– 50 kg/m³: approx. 10.5 t/hour
– 100 kg/m³: approx. 17.5 t/hour
Bale weights (at approx. 1.2 m bale length, depending on material): up to 600 kg
PLC control: Siemens S7-300
Display panel: pulsotronic
Machine dimensions (installed): 8,610 x 2,400 x 3,835 mm (L x W x H)
Transport weight baler: 16 t

Special equipment:
• Wear-resistant floor made of HARDOX steel
• Special press ram for compacting “difficult” materials and loose bulk materials with small particle size
• Control cabinet air conditioning
• Elevated machine feet, 200 mm

Remarks:
The machine has been serviced and partially overhauled in our workshop. The following works have been performed and parts renewed:

• Removal and disassembly of the press ram, maintenance of the mechanics, replacement of the following plastic wear strips and rails:
o Plastic wear strips left/right underneath the press ram
o Plastic wear strips left/right above the press ram
o Central plastic main wear plate (support plate) under press ram
• Steel guide rails (left/right, upper frame) replaced
• Complete four-part floor plate replaced with wear-resistant HARDOX steel
• Wire inlet rails in press floor newly welded and smoothed
• Counter blade replaced (two-part, in frame)
• Knife gap adjusted to approx. 2.5 mm
• Removal and disassembly of the tying and twisting unit, mechanical overhaul, all groove ball bearings and axial ball bearings of twister shafts replaced, wire cutters cleaned and adjusted, chains lubricated and tensioned
• Support roller in front of the twister shafts replaced
• All hydraulic hoses replaced
• Oil and air filters replaced
• Main hydraulic cylinder checked for leaks
• Hydraulic oil is only one year old, was chemically analyzed and is still in good condition, hence was not replaced, but can continue to be used
• General maintenance performed
Kljdpfx Alex A U Ncj Nor

Finally, the baler was tested in manual and automatic mode – see video for machine function test.

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.