UMENJA

Optimum TX5216V Vario

Optimum Optiturn TX 5216V – Used Machine.

Machine bed made from heavily ribbed cast iron
One-piece machine base made from steel
High rigidity of the headstock housing thanks to heavily ribbed 25GG cast iron
Precisely machined carriage
Shafts mounted on needle bearings, all components lubricated in an oil bath
Bed guideways hardened and precision ground
All electronic controls centrally accessible
All feed gearbox gears made of hardened steel
Handwheels decoupled and inspected according to EN 23125
Dual-channel safety electronics
Fedjx Hdq Topfx Ab Tspr
Switches with life-cycle calculation, tested to EN ISO 13849
Full leadscrew and feed screw cover
Fully illuminated work area
Service-friendly removable rear panel
Hardened and ground face plate spindle ensures exceptional accuracy and durability
High material removal rate in rough machining thanks to large cutting capacity
Energy chain for gentle cable and hose guidance
Lockable chip guard travels with the carriage, featuring integrated position indicator and coolant hose, manually adjustable
No change gears required
Equipped with safety device against simultaneous operation of threading and feed mechanisms
Electronic feed stop for the Z-axis
Coolant system with separate coolant tank featuring fill level indicator and oil separator; easy and complete emptying and cleaning as per DIN
Electrical position shutoff with quadruple position stop
Three-jaw chuck included as standard
Quick-change tool post SWH 7-C
Tool holder 32 x 130 type D for 25 mm square tools
Large spindle bore

Dimensions and Weights
Length approx. 2925 mm
Width/Depth approx. 1195 mm
Height approx. 1930 mm
Weight approx. 2470 kg

Work Area
Centre height: 260 mm
Centre distance: 1600 mm
Swing over bed: 520 mm
Swing over cross slide: 324 mm
Bed width: 350 mm

Speed Range
Number of speed ranges: 2 x 3 steps
Speed range: 12 – 1800 rpm

Electrical Data
Output (motor power): 7.5 kW
Total connected load: 5.5 kW
Connection voltage: 400 V
Network frequency: 50 Hz

Coolant System
Coolant pump power: 60 W
Type of generated data: Usage data

Tailstock
Quill taper: MK 5
Quill travel: 180 mm
Quill diameter: 72 mm

Spindle
Spindle mounting: Camlock DIN ISO 702-2 No. 8
Spindle bore/bar pass-through diameter: 80 mm
Tool post: SWH 7C
Spindle taper: MK 7

Thread Cutting
Metric pitch: 0.5 – 15 mm/rev
Number of metric pitches: 55
Imperial pitch: 60 – 2 TPI
Number of imperial pitches: 55
Diametral pitch: 120 – 4 DP
Number of diametral pitches: 55
Module thread pitch: 0.25 – 7.5 mm x π
Number of module pitches: 55

Travel
Cross slide travel: 170 mm
Compound rest travel: 340 mm
Carriage travel: 1400 mm

Feed
Longitudinal feed range: 0.05 – 1.5 mm/rev
Number of longitudinal feeds: 55
Flat feed range: 0.025 – 0.75 mm/rev
Number of flat feeds: 55

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.