Plazemski rezalni stroj

Microstep Mastercut Eco Plus 3001.15

Microstep Mastercut Eco Plus 3001.15
Year of manufacture: 2017
Control: IMSNC
Oxyfuel cutting table: 3000 x 1500 mm
Extraction duct left/right
Plasma source: Kjellberg HiFocus 161i, adjustable 10 - 160 A

Power Source HiFocus 161i PLUS
• Flexible adaptation of the cutting process to required conditions via soft-switch inverter and microprocessor control
• Optimal process management through extremely fast regulation of cutting current
• Process monitoring for torch cooling, ignition time, pilot arc time, short-circuit time during torch ignition and power source
• Operating status and error indication via LED and display
• Analog and serial interface for CNC control integration
• Stepless adjustment of cutting current from 10 - 160 A and for marking from 5 - 25 A
• Optimal piercing thanks to stepless delay for main arc and adjustable current ramp-up
• Adjustable current reduction for corners, start, and end signals of the guidance system
• Automatic display of preset cutting current
• Serial data transfer for diagnostic purposes on PC

Plasma Cutting Technology Contour Cut
• Advancement of HiFocus technology for mild steel
• Optimized for cutting fine inner and outer contours
• High cut quality and contour accuracy
• Holes with angular deviations according to DIN EN ISO 9013 in the range of 2-4
• Minimal angular deviation and smooth cut surfaces
• Excellent repeatability and dimensional accuracy
• No time-consuming reworking – high productivity and low costs
• No additional equipment, software, or new consumables needed
• Standard equipment

Plasma Torch PerCut 200/210
• PerCut 200 plasma machine torch for standard and high-precision bevel cutting
• PerCut 210 quick-change torch with threaded lock for fast and convenient fitting
• Special torches available for special applications
• Higher cutting speeds reduce cost per cut meter
• Long service life of consumables saves resources
• Narrower kerf, resulting in less emissions and waste
• Significantly lower gas consumption compared to competitors due to efficient liquid cooling to the nozzle tip
• Lower noise level thanks to reduced gas consumption
• Bevel cutting up to 50 degrees with standard consumables
• Cutting and marking with the same consumables

Power Source HiFocus 161i
Mains connection: 400 V; 3-phase; 50 Hz
Max. connected load: 28 kVA (100% duty cycle)
Main fuse, slow: 50 A
Protection class: IP 22
Open-circuit voltage: 330 V
Cutting current: 10 – 160 A (100% duty cycle)
Marking current: 5 – 25 A (100% duty cycle)
Cutting range:
- Maximum: 50 mm
Blsdpfx Aey Nd Hyobxjp
- Recommended: 0.5 – 38 mm
Maximum piercing thickness: 30 mm
Weight: 206 kg

Plasma Machine Torch PerCut 200
Quick-change torch PerCut 210
Clamping diameter: 50.8 mm
Plasma gases: O2, N2, Ar/H2
Marking gases: Ar
Swirl gases: O2, N2, air, N2/H2 (F5)

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.