Odprta polprikolica

KRONE Bordwandauflieger

Stanje: novo, številka stroja/vozila: 1acf251a278ec5cde4067a7b1, lastna masa: 5.800 kg, največja dovoljena obremenitev: 22.200 kg, skupna masa: 28.000 kg, konfiguracija osi: 2 osi, velikost pnevmatike: 235/75 r17,5, Further information Chassis: Semi-trailer, fleet use Fine-grain steel welded construction, fifth wheel plate with interchangeable 2'' kingpin Outer frame with slightly sloped design, new version with load-lock profile for attaching tension straps 24 t two-speed landing gear, single-side operation, straight base, without compensating slide Free support foot dimension or free rear swing radius approx. 1920 mm 2 wheel chocks with holders Side underrun protection: aluminium Rear underrun protection: steel Quarter shell mudguards in front of and behind each axle 1 spare wheel carrier for 1 spare wheel, with wheel fastening kit 1 plastic toolbox, with shelf, width=620/height=360/depth=440 mm, lockable with a padlock (padlock not included) Axles & suspension Drum brake axles as per manufacturer's choice Axles/chassis laser-aligned to reduce tyre wear and fuel consumption Air suspension Braking system Two-line compressed air braking system, colour-coded line routing for easy service Spring-loaded parking brake Duomatic connection at the front, without connecting line EBS, Electronic Braking System with EBS socket at front, without connecting cable Note: The trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS! With raise/lower valve Vehicle stability control system Wheels and tyres 235/75 R17.5, make as per manufacturer's choice Steel rims, factory silver Electrics 24 Volt, multi-chamber lights, yellow side LED lighting 2 white position lights at the front 2 white/red lane departure lights at the rear 1 x 15-pin socket at the front, without connecting cable Flooring Anti-slip phenolic plywood, approx. 30 mm thick, for high point loading, suitable for forklift axle loads up to max. 5,600 kg Front wall / corner stanchions Itedpfx Askv Uvzobxsh 25 mm aluminium hollow section, approx. 1,350 mm high, steel corner stanchions in volume version Country of registration / Plates Germany with Dekra inspection and expert report (according to §13 EC-FGV) 24/7 service hotline Prepared for single-line license plate holder Contour marking with reflective tape according to ECE R 048, white on sides and red at rear Paintwork Frame hot-dip galvanized incl. passivation, 15-year warranty against rust-through Front wall aluminium Attention! Archive photos shown!

Stanje: novo, številka stroja/vozila: e7fbe178b85a202cade7e95af, lastna masa: 5 kg, največja dovoljena obremenitev: 22 kg, skupna masa: 29 kg, konfiguracija osi: 2 osi, velikost pnevmatike: 235 / 75 r 17,5, Further Information Chassis: Semi-Trailer for Freight Forwarding Fine-grained steel welded construction, fifth wheel plate with interchangeable king pin, two king pin positions. Outer frame slightly sloped with load-lock profile for attaching lashing straps. Note: When using lashing straps in conjunction with side boards, the side boards must be opened to attach the straps! 2 pairs of lashing rings recessed into the outer frame on the gooseneck, each rated at 5 tons 8 pairs of lashing rings recessed into the outer frame in the low bed, each rated at 5 tons 24-ton two-speed landing gear, single-sided operation, with straight lower section, without sliding compensation 2 wheel chocks with holders Aluminum side underrun protection Steel rear underrun protection Quarter shell mudguards in front of and behind the axle assembly 2 stainless steel toolboxes, width=600/height=400/depth=500 mm, with polished lockable door 2 pairs of stake pockets recessed into the outer frame on the gooseneck, internal dimensions 70 x 40 mm 6 pairs of stake pockets recessed into the outer frame in the low bed, internal dimensions 70 x 40 mm !!Internal width between stakes: 2,420 mm!! 3 lashing/stake rails in the low bed, recessed crosswise into the floor across the entire width up to the outer frame (max. usable internal width between external drop-in stakes approx. 2,170 mm), approx. 100 mm high. With 20 mm round bar rails, top and bottom, approx. 60 mm clearance between the round bars (top to bottom). Bottom finished with angle plate, half open to below. For lashing and setting stakes 80 x 80 mm. Quantity: Drop-in stakes B=80/T=50/L=1200 mm, hot-dip galvanized Quantity: Drop-in stakes B=80/T=80/L=1200 mm, hot-dip galvanized Note: Stake pockets / drop-in stakes are not intended as the sole means of load securing for long materials, pipes, etc. without lashing. Rear extension manual with hand crank, extendable approx. 1,500 mm, lockable every 500 mm, with support beam; load capacity at center of gravity: approx. 2,000 kg over entire width at 500 mm, 1,000 kg at 1,000 mm, 500 kg at 1,500 mm; includes extendable rear underrun guard with lighting. 2 pairs of drop-in stakes B=80/T=80/L=1200 mm, hot-dip galvanized Open storage compartment for drop-in stakes at the front wall or below the load area (for 10 drop-in stakes 80 x 50 x 1200 mm and 4 stakes 80 x 80 x 1200 mm) Axles & Suspension SAF drum brake axles Axles/chassis laser aligned, reduces tire wear and fuel consumption Last axle is steering, with automatic reverse lock via reverse light and additional manual lock on the vehicle via a hand button. Air suspension with raise & lower valve Wheels and Tires 235 / 75 R 17.5 Manufacturer’s choice Steel twin rims, factory silver Braking System 2-line compressed air brake system Spring-actuated parking brake 2 foolproof coupling heads at front, without connecting line EBS, Electronic Braking System with EBS socket at front, no connection cable Attention: The trailer may only be towed by vehicles that ensure ABS effectiveness! Axle load detection via EBS CAN bus signal, for display in driver’s cab; truck must be properly equipped, no truck installation (not a calibrated scale) Electrics 24 volt, multi-chamber lights, side yellow LED lighting 2 white position lights at front 2 white/red lane marker lights at rear Iedsi Ri Hvopfx Abxoth 2 x 7-pin sockets at front, without connecting cables 2 additional LED work lights at rear, switched via reverse light 1 LED rotating beacon with bracket, switch