Jowat lepilo EVA-hotmelt

JOWATHERM JOWAT 280.30/ 280.31

EVA Hotmelt Without Filler 280.30/31

Examples of Application:
Edge Banding
For bonding thermoplastic edge bands (such as ABS, PP, PVC), resin-impregnated decorative paper or veneer edge bands (with/without nonwoven backing), and solid wood edges.

Fundamentally, the bond characteristics and the surfaces to be bonded on the substrates (including reverse-side primers or other surface pretreatments) must be checked for their suitability prior to use for the intended application.

Instructions for Use:
Automatic feed systems can be used for processing the adhesive granules. During processing, an ambient temperature of 30°C should not be exceeded.

Different hotmelt types may show incompatibility with each other depending on the formulation. Therefore, we recommend thoroughly cleaning the application equipment when changing products. Further information available upon request.

The processing characteristics can vary depending on the application technology used and/or different feed speeds, which may affect the bonding process.

Customer trials are required!

Kwsdpfxex Sqnvs Abbot
Typical Technical Data:
Processing temperature (°C): 180 – 200
Feed speed (m/min): 10 – 40
Appearance: code ending in 0 = opaque yellow
code ending in 1 = white
Density at 20°C (g/cm³): approx. 1.03 ± 0.03
Softening range (°C): approx. 90 ± 5 (Kofler heating bench)
Viscosity at 190°C (mPas): approx. 66,000 ± 10,000
Heat resistance (°C): approx. 80 ± 5
Open time at 190°C (s)*: approx. 6 ± 2
Setting time: not applicable
* measured on a 200 μm film
Technical data determined according to Jowat testing methods

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.