Univerzalni obdelovalni center

DMG MORI DMU 60 evo

We offer you the following:

Technical data:

Controller: Heidenhain iTNC 530 HSCI

Travel ranges:
- X-axis travel: 600 mm
- Y-axis travel: 500 mm
- Z-axis travel: 500 mm

Main spindle:
- Speed range: 20 – 18,000 rpm

NC rotary table:
- Clamping surface: 600 x 500 mm
- Maximum load: 400 kg
- B-axis: -5° to +110°
- C-axis: 360°

Tool changer:
- Tool holder: HSK-A63
- Number of tool positions: 210

Equipment and accessories:
- Heat exchanger for spindle and table
- Active cooler for control cabinet
- Direct measuring system
- Full enclosure
- 3D control
- DMG ERGOline control
- Direct measuring systems in NC swivel rotary table incl. table cooling
- Laser tool measurement BLUM NT
- Calibration arbor with tool holder
- Infrared probe, Heidenhain TS 649
- Prepared for 3D quickSET
- Scraper belt chip conveyor
- ICS (internal coolant supply), 40 bar, 600l tank, incl. rotating inspection window, barrier air, linear measuring systems, bed flushing
- Rinsing gun
- Mechanical oil and emulsion mist separator
Nodjxgnz Tepfx Afgocp
- Air blast through the center of the spindle
- Operating mode 4
- Machine preparation for handling systems, consisting of:
- Automatic, lateral loading door
- Electrical interface for articulated-arm robot
- Pneumatic control and monitoring of the zero point clamping system
- Selection/deselection of handling system via switch on the machine control panel
- Incl. additional rinsing in the working area
- Incl. machine preparation for job management
- Incl. control panel arrangement left
- Energy supply to the machine table incl. two-channel rotary union
- Additional machine-side clamping hydraulics, 1 clamping circuit:
- Clamping hydraulics, 1 circuit, 30 – 240 bar, pressure adjustment via proportional valve technology
- Incl. rotary union extension to 4 channels

Power-on hours: approx. 66,600 h
Spindle hours: approx. 44,800 h

The robot shown in the images is not included in the scope of delivery.
The machine will be available approximately from October/November 2025.
The ball screws and linear guides in the X and Z axes have been renewed.

Accessories, pictured tools, and clamping devices are included in the delivery only if explicitly stated in the additional information.
Technical data, specifications, and prior sale subject to change and errors!

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.