Stiskalnica za okvir Stiskalnica za lepljenje

Z.V.B. Sonno

Z.V.B. Carcass Press Sonno
Manufacturer: Z.V.B.
Designation: Carcass Press
Type: Sonno
Max carcass size: 1790 x 1280 mm
Operating voltage: 400 V
Connected load: 3 kW
Operating pressure: 7 bar
Beijer Electronics E300 Operator Interface panel
Controller: Mitsubishi Melsec FX2N-64MT-DSS
SICK light curtain
2 hand switches
Year of manufacture: 1997

General operating description
The work process can essentially be divided into the following steps:

Program input
Retrieve the program number for the carcass from the list and enter it using the keypad. Confirm the entry by pressing the Enter key. The press will now move to the preset dimension for this carcass.

Pressing process
1. Once the position is reached, the cylinders for the base support and the left lateral stop extend.
2. Now place the left panel onto the base support. The panel is automatically held in place by a vacuum suction device.
Kdedpfx Asvdbpvedpsw
3. Then insert the base panel and press it lightly into the dowel holes of the left panel.
4. Afterwards, insert the right panel and connect it to the base panel.
5. By pressing the + key, the base is now pressed together with the side panels.
6. Now insert the back panel and fit it onto the dowels.
7. By pressing the + key, the back panel is pressed together with the side panels.
8. Now check if all connections are properly seated and if the carcass is square.
9. If all parts are correctly connected, apply the final pressing pressure by pressing the + key again.
10. You can undo each step individually by pressing the - key.

Releasing the press
1. Once you have completed all work on the carcass, end the pressing process by pressing the release key. The pressure cylinders switch off and the carcass is held in place by the two lower cylinders.
2. As soon as the cylinders for the base support have retracted, place the transport pallet onto the roller rails.
3. By pressing the release key again, the carcass is set down on the pallet and can be slid onto the conveyor belt.

Next carcass
1. Once the press is empty again, press the + key. The press now returns to position for processing the next carcass of the same type.
2. If a carcass of a different type needs to be pressed, return to the input page by pressing the F6 key.

Find more new and used items in our shop!
International shipping costs on request!

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.