WPM 400-C

WPM WPM 400-C

The machine is currently undergoing refurbishment.

PROCESSABLE MATERIALS
Fpjdpfxjyuuzde Ap Eok
Depending on material properties and sheet configuration:
- Paper with a basis weight of at least 80 g/m²
- Cardboard or solid board up to a basis weight of 2,000 g/m² and corrugated board up to a total thickness of 4 mm (maximum sheet curvature 4%)

PERFORMANCE DATA
Maximum sheet size: 820 x 1,130 mm
Minimum sheet size: 350 x 400 mm
Maximum cutting force: (400 t) 4.0 MN
Maximum machine speed: 9,000 sheets/hour

Basic equipment of the machine:
Feeder
High-performance non-stop sheet feeder W3 equipped with:
• Automatic non-stop device
• Automatic pallet change system
• A suction head
• Double sheet detector
• Motorized pile side lay adjustment
• Motorized suction head adjustment
• Belt table with pneumatic cover frame
• Compressed air and vacuum pump

Register table
• Operator side side lay, can be switched between pull or push mode
• Light sensor for precise sheet side alignment detection
• Fine adjustment of side lay
• Two active front lays with light barrier for register control
• Two inactive front lays for stabilization of sheet registration
• Separate fine adjustment of the gripper margin for drive and operator side
• LED display for correct front and side lay registration
• Arrival trend display for sheet feed
• Miss sheet rejection which disables only the feeder
• Height-adjustable top lay for precise sheet guidance

Die-cutting station
• Roller-guided support rails for the chase
• Roller guidance for the cutting plate on swing-out carrier arms
• Motorized adjustment of die-cutting pressure
• Automatic device for raising the chase to the platen
• Electronic cutting force display with maximum pressure limitation
• Vacuum unit under the table for thin die-cutting plates

Stripping section
• Frame drive and frame lift for the upper tool frame
• Stripping board holder with Centerline fine adjustment
• Device for sample sheet removal
• Upper tool frame
• Lower tool frame

Delivery section
• Fully automatic package stacking device, pre-selectable
• Counted part piles by automatic insertion of uncut sheets
• Can form sheet bundles (interleaving sheet weight min. 250 g/m², max. 800 g/m²)
• Frame lift for the upper tool frame
• Holder for change frames with motorized adjustment in running direction
• Pneumatic frame locking
• Selectable gripper opener cam and sheet pusher
• Sheet alignment device
• Integrated conveyor belt for removing gripper edges or waste grid (double cut)
• Separator sheet magazine with electronic level control, refillable from the B-side during production
• Tool frame with Centerline
• Change frames for standard sheet delivery / gripper edge removal
• Change frames for stripping grid
• Mounting kit for separator punch
• 8 x sheet hold-downs for standard sheet delivery
• 4 x cross support rods

Options:
• QTM – Patented guide rails
• QTM – Chase with quick lock system and X/Y adjustment
• QTM – Upper stripping frame with quick lock system
• QTM – Upper delivery frame with quick lock system
• Control system retrofit to latest Siemens S7 controller
• New generation frequency inverters
• Modem for remote service connectivity
• Machine height extension: 900 mm

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.