Stroj za termoformiranje / stroj za blister

Uhlmann UPS4ET

Uhlmann Thermoform Packaging System
UPS 4 ETX
for processing PVC forming film
and aluminum lidding foil
Dsdpfstndpzex Aa Dskt
Base machine with modular technology and balcony design, consisting of 12 modules:

- Forming film unwinding unit
with 2 pneumatic expanding shafts
for core diameter 76 mm,
max. roll diameter 800 mm
- Cutting and splicing table for forming film
- Intermittent forming film unwinding
- 3-zone contact heater:
- 6 heating circuits, individually controllable
- simultaneous heating of at least 3 advances
- heating plates open automatically when machine stops
- Forming station with 4-column lift table guidance
- Filling section, length 1,360 mm
- Safety cover in filling area
Lidding foil unwind on operator side
with pneumatic expanding shaft
for core diameter 76 mm,
max. roll diameter 300 mm
- Plate sealing station with 4-column lift table guidance:
- integrated overload protection
- automatic lifting of the upper sealing tool when machine stops
- Free module for installation of an additional station
- Indexing chain feeder
- Punching station with blister lowering
- Waste cutter with integrated motor-driven transport of the punching grid
- Smoothing device
- Perforation station ET/DT
- Monitoring of compressed air supply with machine stop if minimum value is not reached
- Visio Scan
- electrically interlocked safety doors
- Fast format change due to:
- plug-in format parts
- quick-connect couplings for cooling water supply
- Main drive with frequency-controlled three-phase geared motor
- Control cabinet at machine rear, swing-mounted
Operating control Paccontrol
- 10.4" TFT color display, resolution 640x480 pixels
- Processor 68C030
- Operating system OS9 2.9
- 2 MB SRAM, 2 MB Flash, 16 MB DRAM
- SRAM card reader
- IBM standard membrane keyboard
- Centronics interface for external printer
- PS2 interface for external keyboard
- VGA interface for external monitor
- Serial interface for diagnostic purposes
- Arcnet interface
- 8 serial interfaces for connecting devices
Integrated shift register ISR
Rejection of individual blister rows,
e.g. overheated film in the heating station,
products in the sealing station, etc.
Machine control:
Programmable logic controller in modular design:
- B&R PLC control
- Bus system with modules for CPU, inputs,
outputs, temperature controller, cam controller, etc.
- external program memory

Technical Data UPS 4 ETX:

- Cycles:
- ET area: min./max.: 15/50 cycles/min.
depending on film quality, feeding, and format design

- Format range:
min./max. advance in filling area: 64/226 mm
min./max. film width: 100/300 mm
min./max. punching width: 28/284 mm
max. forming depth: 12 mm
- Compressed air:
- Input pressure: approx. 6 – 8 bar
4 Simtap feeders

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.