Polpriklopnik kiper

STAS OP-V 11.40 63m³

Nick chassis cranked (approx. 80-100 mm lower)
Made of high-quality ALU-MG-silicon alloy, two fully-automated welded I-section longitudinal beams with welded crossmembers. Chassis width: 1,600 mm!

Axles and suspension, wheelbase optimized for improved tracking
Jost (DCA) axle assemblies 22.5" / 3 x 9 t with DC air suspension, 3rd axle liftable, 1st axle with traction aid and electric actuation (switch already installed in the tractor unit), raise/lower valve for air suspension, Wabco Smartboard,

Tyres and wheels
6 wheels with 385/65 R 22.5 tyres approx. 50–60% tread on Alcoa satin aluminum rims, ET 120 11.75 x 22.5

Landing legs
Mechanical landing legs with compensating feet, single-sided operation, 2 speeds, with 2x20 t support load

Lajdpfx Abexfn Drohoi
Brake system
According to EEC standard, dual-circuit Westinghouse system, spring-loaded brakes acting on two axles, Wabco EBS system with RSS (Roll Stability Support), premium modulator, ALU air tanks

Electrical system
According to StVZO guidelines, with 2x five-chamber lights (Aspöck type), 24-volt system, 2x 7-pin and 15-pin sockets, with side LED position lights, halogen reversing lights at the rear and one on a stand at the bulkhead (switchable from outside), Volvo reversing camera (without SZM equipment). All air and electrical lines neatly routed in plastic tubing!

Tipper body/skip: Skip fully welded inside,
Aluminum skip, side walls 30 mm / 600 mm plank profiles, 3 mm inside/2 mm outside, floor 8 mm highly reinforced and wear-resistant (5383H34-HB110), 45-degree profile, front wall 4 mm straight with internal ladder, rear wall twin-leaf door, 2 leaves (1/2-1/2) each with grain slider, rear doors partly clad in smooth aluminum, rear bow out of aluminum, swing-out, two hold-downs with rubber buffers secured to the skip frame at the front wall,

Hydraulic system with large housing (new in 8.2025)
Hydraulic cylinder mounted on the front wall, operating pressure 150 bar, make Edbro, approx. 2.5m hydraulic hose with loose half 1", tipping angle approx. 48 degrees

Accessories
6 PVC mudguards with 2 rear rubber mud flaps, retractable splash flap at underrun guard, side underrun protection as per StVZO, aluminum spare wheel holder, foldable underrun guard (ALU) with towing eyes, roof tarpaulin with lateral tension belts, 2 longitudinal tension belts for securing from the catwalk, 30 mm tarp pipe welded centrally into canvas, tarp support at rear in aluminum sheet (approx. 150 mm), 4 aluminum swing bows, 2 plastic toolboxes (Type 800), approx. 3 m aluminum ladder, catwalk on skip with access left/right, 2 plastic wheel chocks with bracket on chassis, small extendable ladder at rear, separate ALU discharge chute with tarp sack, etc.

Offer and pictures subject to change.

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.