Sistem laserskega taljenja

Renishaw RenAM 500 S-FLEX

Processable Materials: Metals in powder form. This includes, for example, stainless steels and tool steels, aluminium alloys, nickel-based alloys, and titanium alloys. For further information on materials and surface quality, please refer to our website.

Weight (net): 1,870 kg
Laser Type: Ytterbium Fiber
Hjdpfxsv Ewpnj Ah Donu
Laser Power: 1 × 500 W
Dimensions: 2,165 mm x 1,236 mm x 2,130 mm (L x W x H)
Build Volume (1): 250 mm × 250 mm × 350 mm (L x W x H)
Powder Layer Thickness: 20 μm to 120 μm
Typical Process Speed (3): 2 m/s (max. 10 m/s)
Build Rate (2): Up to 254 cm³/h
Beam Focus Diameter: 80 μm with dynamic focus
Dynamic Focus Diameter: Up to 500 μm
Beam Wavelength: 1,070 nm to 1,080 nm
Laser Modulation Frequency (max.): 20 kHz
Build Chamber Atmosphere Preparation Time: 15 minutes (to < 1,000 ppm oxygen content)
Consumption During System Fill/Emptying: < 1,200 l
Maximum Argon Consumption (during filling): 400 l/min
Ongoing Argon Consumption (after initial fill): < 0.8 l/min
Working Pressure in Chamber: 10 mbar to 20 mbar
Argon Gas Supply Connection: 3/8 in BSP quick-connect fitting
Argon Quality: 20 ppm permissible impurity or better (purity level of 99.998%)
Power Supply (4): 380 V to 480 V AC, 63 A, 50 Hz to 60 Hz, 3-phase
Data Ports (5): Standard network port RJ45. Renishaw recommends Cat 6 power class network cables.
Ideal Operating Temperature (7): 18 °C to 22 °C (min./max.: 15 °C to 28 °C)
Ideal Relative Humidity (7): < 60% (max. < 80%)
Clearance Under Machine (without base): 146 mm
Optical Module Protection Class: IP5X
Noise Level: ≤ 70 dB
Compatible Software: QuantAM, InfiniAM Camera, InfiniAM Spectral, Renishaw Central, and selected third-party software

(1) Build volume refers to the maximum space from wall to wall; the actual usable area may be smaller. The substrate plate is not included in these dimensions.
(2) The maximum build rate does not include recoating time and depends on parameters, component geometry, and material.
(3) Typical process speed depends on parameters, component geometry, and material.
(4) The calculated maximum machine load is 50 A; the nominal operating current is 32 A.
(5) The user can configure the network with their own control software. For more details, see the RenAM 500 Series Additive Manufacturing System user manual, Renishaw part no. H-5800-3693.
(6) Due to differing electrical requirements by country, part numbers for additional equipment may vary. Please contact your local customer service for any questions regarding this matter.
(7) Temperature and humidity must not simultaneously reach their specified maximum values and must remain below the dew point of 16 °C (61 °F) to prevent condensation on the laser components. See the Site Preparation and Installation Guide for the RenAM 500 Series Additive Manufacturing System, Renishaw part no. H-5800-3692.

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.