Nadpasovni magnet Blok magnet Magnetni disk

mütek Hawk-Eye

Stanje: novo, Leto izdelave: 2025, Diameter: 160 mm Available at extra cost in diameters: 180, 200, 250, 300 mm; other diameters available upon request. Very robust industrial design. Ideal for separating nails and metal parts from material flows, for example after a wood shredder. Includes 3 ultra-high-performance magnets * Up to 6 magnets can be installed in the unit upon request – surcharge per additional magnet: €49 - Neodymium magnets available at additional cost instead of ferrite magnets Your advantages: + Extremely large inspection door with gasket for easy removal of nails + Sturdy quick-release fastener + Made in Germany Dcjdpfechuvrex Adhen Inspection door/opening: 35 x 18 cm Installation length may vary.

Leto izdelave: 2025, Stanje: novo, *Only the neodymium overband magnet is offered, not the conveyor belt underneath. *Neodymium magnets are among the strongest magnets in the world. They have extremely high holding force and cannot be compared to ferrite magnets. Extremely high separation efficiency, depending on the material height and input material. Probably the most compact overband magnet on the market. Competitors often use the less powerful ferrite magnets to save costs. Approximate dimensions: Length: 104 cm Width: 22 cm Height: 28 cm (at the motor) Dedpfx Adodubpushocn *Without control system Surcharge for simple manual start/stop control: + €495 A high-performance industrial neodymium magnet is installed. High-performance neodymium magnet approx. 600 x 68 x 36.5 mm * Over a length of 600 mm, nails are attracted and discharged sideways once outside the magnetic zone. This overband magnet should be installed approx. 7–10 cm above the material flow. *Mounting/suspension to be provided by the customer *depending on the maximum length of the metal pieces. Ideal for separating nails from wood chips. Optionally used in a single-shaft shredder with extraction. Requirements: * Your belt width or effective inner width (of the existing conveyor belt) should ideally be less than 55 cm *Suitable for separating nails from material flows less than 12 mm high, as well as chip lengths less than 25 mm. ----- Optional at extra cost: Cross and incline conveyor demo units from €8,770 net