Trivaljna valjčna stiskalnica

Kramer RHM III 120/1000

Type RHM III 120 v-1000
Roller Diameter: 120 mm
Usable Length: 1000 mm
Sheet Thickness: up to 5.0 mm
400 Volt
Lodpfx Asx Niu Njh Asak
Kramer Maschinenbau GmbH

Description
The features described for the RH II series also apply to the RHM III series. These round bending machines are designed for continuous operation under maximum load. The lower roll is adjustable via a worm gear drive.

For model sizes RHM III 90 – RHM III 130, the geared brake motor is externally flanged, while models RHM III 140 to RHM III 180 are equipped with an internally flanged geared brake motor.

All motor-driven machines are equipped as standard with an electrical safety control system. Operation for forward and reverse is performed via a double foot switch.

Additional features of Type RHM III
▪ Powerful thermally protected geared brake motor
▪ Electrical safety control system
▪ Convenient double foot switch for forward and reverse operation
▪ Three-roll drive (especially recommended for thin sheet metal)
▪ Drive system with 2 working speeds
▪ Overload protection via slip clutch
▪ Motorized rear roll adjustment
▪ Motorized lower roll adjustment

Standard equipment
▪ Gear train
▪ Three-roll configuration
▪ Asymmetric roll arrangement
▪ Upper roll swings out to the front
▪ Manual adjustment of lower and rear roll via handwheel
▪ Conical bending via angular adjustment of lower and rear rolls
▪ Pre-bending performance = round bending performance

Optional equipment
▪ Device for conical rounding
▪ Upper roll with grooved edge
▪ Lower and rear rolls with wire insert groove
▪ Surface-hardened rolls
▪ Ground rolls

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.