Stroj za robno lepljenje

IMA NOVIMAT / CONTOUR / I / G80 / 790 / L20

Single-sided edge banding machine for narrow edges IMA NOVIMAT / CONTOUR / I / G80 / 790 / L20 with MFA servo unit for corner copying
Year of manufacture: 2009
Technical condition: very good

- Stable machine frame, onto which individual machining units are mounted.
- Feed drive with electronically adjustable feed speed range from 6–30 m/min
(machining unit operating speeds are not synchronized with the full range of feed adjustment).
- Feed chain guided in low-friction guides with plastic pads and 80 mm wide rubber covering.
- Automatic feed chain lubrication controlled by the machine program.
Djdpfx Adsw R S Slshjcn
- Upper pressure beam made from a double V-belt, 70 mm wide, guided on ball bearing-supported rollers; pressure beam is electronically adjustable.
- Safety guards corresponding to CE certification.
- Soundproofing and protective enclosures.
- Edging unit with drive installed in a fully enclosed oil bath with glue pot
(1 main powered pressure roller + 5 auxiliary rollers); pneumatic Quick-Lock glue pot fast-change system.
- Touch-screen display.
- End trimming unit for cutting off edge overhang at front and rear corners,
with features including: pneumatic saw tilting 0–25°, straight and chamfer cutting,
automatic saw positioning for corner chamfering for two different edge thicknesses (e.g. 0.4 and 1.2 mm)
and adjustment of edge overhang cutting for corner copying.
- All machining units equipped with chip extraction.
- Novimat Contour series edge banders ensure very high processing quality due to the powerful corner copying unit and small gap between workpieces (~300 mm).

Key technical data:
- Edge material from roll thickness: from 0.3 to 3 mm
- Paper, PVC and ABS edges: 0.3–3.0 mm
- Veneer: 0.5–3.0 mm
- Solid wood strips: 0.8–20 mm
- Edge height: 14–65 mm
- Maximum top edge overhang:
• for edge thickness up to 8 mm – 5 mm
• above 8 mm – 2 mm

Workpiece dimensions:
- Minimum workpiece length in feed direction: 150 mm
- Minimum workpiece width (for up to 25 mm thick elements): 65 mm
- Minimum workpiece thickness: 8 mm (without flat scraper) or 12 mm (with flat scraper)
- Maximum workpiece thickness:
• without corner copying: max 60 mm
• with corner copying: max 40 mm
- Smallest element: 150 × 150 mm or 65 × 300 mm
(note: * 65 mm width at maximum workpiece thickness of 25 mm)

Machine technical parameters:
- Workpiece feed speed electronically adjustable: 6–30 m/min
(note: feed speed may be limited by specific units on the machine)
- Workpiece overhang beyond feed chain:
• 38 mm (with edge thickness 0.3–8 mm)
• 30 mm (with edge thickness 8.1–20 mm)

Electrical supply:
- Voltage: 400/230 V, +5/–10 % with neutral
- Frequency: 50 Hz
- Control voltage: 230 V AC / 24 V
- Compressed air: 8 bar
- Extraction air speed: 28 m/s

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.