Stroj za tlačno litje z vročo komoro - Vertikalni

FRECH DAW 80S

Clamping force 900 kN
Clamping plate 540x540 mm
Distance between tie bars 350x350 mm
Machine weight approx. 5.5 t
Clamping stroke 280 mm
Ejector force 60 kN
Ejector stroke 70 mm
Mould height 160-400 mm
Tie bar diameter 65 mm
Injection force 75 kN
Injection stroke 130 mm
Injection plunger diameter 50, 55, 60 mm
Injection volume (DIN 24480) 119, 163, 214 cm³
Specific injection pressure 380, 315, 265 kp/cm²
Corresponding parting face 236, 285, 340 cm²
Withdraw stroke 150 mm

Fully overhauled DAW 80 GO die casting machine with DataLogic control for use with zinc alloys.

Excerpt from the general overhaul:
- Machine upgrade with new control cabinet and new operator panel, including replacement of all electrical wiring
- Renewal of hydraulics (blocks and valves)
- Clamping unit overhaul
Detailed information upon request

The machine is equipped with the following options:
Dsdpfoyzt D Eox Af Sjur
- Motor-driven safety door, casting direction left
- Chute cover at machine base (straight)
- Standing operator panel
- 1.0.2 Chute cover at machine base
- 3.2.4 Multi-chamber holding and melting furnace with TOC pump
- 3.2.1 Furnace control cabinet for furnace type Z
- 4.0.1 Use of water-glycol
- 4.2. (side) GO
- 6.1.3.1 Wired signal interface for part removal (DISPO10)
- 6.5.2 Equipment package RSD with switch
- 7.2.2.2 Spraymotion 611 E with servo drive, single-circuit
- 7.3.1 Release agent tank TD 20
- 7.4.0.3 Spray bar CR 275

Further options can be offered as agreed.

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.