Nizki nakladalnik

Fliegl TPS 118 Bau m Heckanschrägung

Further information
Chassis Central-axle trailer
Fine-grain steel welded construction
6 pairs of lashing eyes screwed into the floor/external frame, each rated at 5 tons
2 additional pairs of lashing eyes screwed into the floor, each rated at 5 tons, in the corners
Gear support leg at the front
Foldable rear support
2 wheel chocks with holder
Steel underrun protection
Full-width rear mud flaps
Quarter-shell fenders
1 plastic toolbox with shelf, dimensions 620mm (w) / 360mm (h) / 440mm (d), lockable with a padlock (padlock not included)
Central-axle trailer towing device
Drawbar with certified 40 mm towing eye
Drawbar height adjustable via spindle, max. adjustment range 300 mm
Tedpsi Rixrefx Ab Sod
Axles and suspension
Drum brake axles, manufacturer’s choice
Axle/chassis laser alignment to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel/rubber bushings and mechanical axle load equalization (rocker compensation)
Wheels and tires
235/75 R 17.5
Manufacturer’s choice
Steel rims, factory silver
Brake system
2-line compressed air brake system
Hand spindle parking brake
Integral air reservoir
2 non-interchangeable coupling heads at the front, with connecting lines to the towing vehicle,
ABS and ALB, with ABS plug at the front, with connection cable
Electrics
24 volt, multi-chamber lights, side yellow LED lighting
2 white position lights at the front
2 white/red lane marking lights at the rear
2 x 7-pin non-interchangeable plugs at the front, with connection cable
Floor
Steel/Tread plate floor for high point load capacity
Note: Minor floor waviness possible due to welding distortions!
Platform length approx. 5,200 mm
Rear slope approx. 900 mm
Front wall / corner posts
25 mm aluminum hollow profile, height 400 mm
Sideboards
25 mm aluminum hollow profile, height 400 mm, foldable and removable
Rear wall / rear corner posts
1 pair of steel posts attached to the frame with bracket for ramp locking, entry width approx. 2,430 mm
Loading ramps
2 steel ramps, 2,300 mm long, 510 mm wide, laterally adjustable with handle on the ramps
Covered with 3 toothed steel rails
With gas pressure springs for single-person operation
Country of registration / plates
Country of registration: Germany
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Paintwork
Frame hot-dip galvanized incl. passivation
15-year warranty against rust-through
Front wall: aluminum
Sideboards: anodized aluminum
Loading ramps: hot-dip galvanized
Attention! These are archive images.

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.