Nizki nakladalnik

Fliegl SDS 470 T mit Radmulden

Further Information
Vehicle consisting of:
Chassis low-bed semi-trailer
Steel welded construction, kingpin plate with replaceable double kingpin and two kingpin positions
24-ton, 2-speed landing gear, single-sided operation, straight lower section, without thrust compensation
Foldable rear support
2 wheel chocks with holders
Side underrun protection, aluminum
Quarter mudguards in front of and behind the axle assembly
1st pair of wheel recesses embedded in the low-bed drive lane area after the gooseneck, tapered for entry. Lower length approx. 1,600 mm, recess depth approx. 260 mm. Note! Frame in the main beam area is 260 mm higher than the wheel recess.
2nd pair of wheel recesses between axles A and B. Lower length approx. 350 mm, depth approx. 260 mm. Note! Frame in the main beam area is 260 mm higher than the wheel recess.
If wheel loaders are to be transported and the total height needs to be checked, please provide technical data sheets of the wheel loader types with exact information (if total height is exceeded -> customer responsibility, approval required), (depending on ground clearance under the machines, inserts in the wheel recesses may be required by the customer)
Wheel recess covers extendable from the main frame, with wooden inserts.
Extensions extendable to 3,000 mm (not in the rear bevel and not in the lower wheel recesses). (The track width of construction machines or vehicles to be transported must not exceed the external frame width of 2,550 mm.)
Storage compartment for wooden planks on the gooseneck, crosswise at the front
70 mm planks for extension to 3,000 mm
Lashing eyes low-bed trailer
2 pairs of ring lashing eyes, each 5t at the front on the gooseneck
11 pairs of lashing mushrooms recessed at the top and side in the external frame, each 10t
2x on gooseneck, 9x distributed on low-bed platform; first lashing point 250 mm from the front and last at max. 250 mm from the rear, distance between lashing points no greater than 1,100 mm
8 pairs of stake pockets recessed in the external frame, internal dimensions 70 x 40 mm, or instead of stake pockets, 5t ring lashing eyes recessed in the floor
Gsdpfxei Ri Hcj Ah Dsuh
Axles & Suspension
SAF drum brake axles
Axles/chassis laser-measured to reduce tire wear and fuel consumption
Air suspension
Wheels and tires
235 / 75 R 17.5
as per manufacturer's choice
Steel rims in twin arrangement, factory silver
Brake system
2-line compressed air braking system
Spring-loaded parking brake
EBS, electronic braking system with EBS socket at the front, without connection cable
Attention: The trailer may only be towed by tractors that ensure the effectiveness of ABS!
2 non-interchangeable coupling heads at the front, without connecting line
with lift & lower valve
Axle load detection via EBS CAN bus signal, for display in the driver's cab (truck must be pre-equipped accordingly, not installed on truck; not a calibrated scale)
Vehicle stability control system
Electrics
24 Volt, multi-chamber lights, side yellow LED lighting
2 white position lights at the front
2 white/red lane mark lights at the rear
2 x 7-pin, non-interchangeable sockets at the front, without connection cable
1 x LED beacon with holder, switched via parking light (lamp removable)
2 pairs of warning panels, double LED illuminated and extendable to 3,000 mm, removable with plug
Floor
Gooseneck with steel/chequer plate covering
Storage box embedded in the sloped transition to gooseneck
Then with 70 mm softwood floor; in the lower wheel recesses and w

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.