Nizki nakladalnik

Fliegl DTS S 300 Parab/Feder

Further Information
Chassis Low-Loader Trailer
Steel welded construction
Turntable with robust ball bearing slewing ring
Foldable rear support
2 wheel chocks with holder
Side underrun protection made of aluminium
Full-width rear spray flap
Half-shell mudguards on 1st axle with anti-spray flaps, anti-spray flaps behind 2nd and 3rd axle
1 plastic toolbox with shelf, dimensions: width=620 mm / height=360 mm / depth=440 mm, lockable with padlock (padlock not included)
Extendable width up to 3,000 mm
Storage compartment for wooden planks in the centre of the loading area
70 mm wooden planks for extension to 3,000 mm
Tie-down lugs for low loader (40 lashing points)
1 pair of lashing cut-outs in the longitudinal beam at the front, recessed into the gooseneck, each rated at 10 t
4 pairs of lashing holes in the outer frame, each rated at 5 t (for securing with lashing straps)
7 pairs of lashing mushrooms, recessed at the top and side of the outer frame, each rated at 10 t
1 at the front on the gooseneck
6 in the low bed
First lashing point 250 mm from the front, last max. 250 mm from the rear, spacing between lashing points not greater than 1,100 mm
5 pairs of stake pockets recessed in the outer frame, interior dimensions 70 x 40 mm (convertible to 5 t ring lashing points, not included)
2 additional pairs of folding lashing rings, each rated at 10 t
1 on the gooseneck (protruding)
1 behind the last axle, recessed in the floor
Towing Device Turntable Trailer
Drawbar with certified 40 mm towing eye
Axles and Suspension
Drum brake axles, manufacturer’s choice
Axle/chassis laser alignment to reduce tyre wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load equalisation (rocker equalisation)
Wheels and Tyres
235 / 75 R 17.5
Manufacturer’s choice
Steel rims, twin arrangement, factory silver
Braking System
2-line compressed air braking system
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front with connecting lines to the tractor unit
ABS and ALB, with ABS socket at the front and connecting cable
Manufacturer: Wabco or Knorr
Electrics
24 Volt, multi-chamber lights, side yellow LED lighting
2 white position lights at the front
2 white/red lane lights at the rear
2 x 7-pin non-interchangeable plugs at the front with connecting cable
1 LED beacon with bracket, switched with parking lights (removable beacon)
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm
Floor
Gooseneck at the front with steel/chequer plate covering
Pjdpfx Aaji Ri Ddeferc
Toolbox recessed into transition slope to gooseneck
Following area with 70 mm softwood floor, steel/chequer plate in wheel arch area
Rear taper with 70 mm softwood floor
Low-loader deck including rear taper: 6,500 mm
Loading ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Timber surfaced
With spring lift assistance
Country of Registration / License Plates
Country of registration: Germany
24/7-Service Hotline
Prepared for two-line license plate holder
Contour marking with reflective strips according to ECE R 048, white on sides, red at rear
Warning sign according to ECE-70
Painting
Frame hot-dip galvanized including passivation
15 years’ warranty against corrosion perforation
Drawbar galvanized or black, manufacturer’s choice
Loading ramps hot-dip galvanized
Attention! Archive images shown!

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.