Nizki nakladalnik

Fliegl DTS 300 P mit Radmulde

Further information
Chassis Low-loader Trailer
Steel welded construction
1st pair of wheel recesses embedded in the driving lane area after the steel platform, bevelled for entry, approx. 1,400 mm long at the bottom, approx. 400 mm deep. Note!
Frame is 400 mm higher in the main beam area than at the wheel recess.
If machines are to be transported where overall height must be verified, we request a technical data sheet for the machine types with precise specifications (if overall height is exceeded -> customer is responsible, approval required). Depending on ground clearance under the machines, inserts for the wheel recesses may be required on the customer side.
Turntable with robust ball race ring, storage box integrated in the turntable front section
Rear supports foldable
2 wheel chocks with holder
Aluminium side underrun protection
Full-width rear mudflap
Extending wideners to 3,000 mm (not in rear bevel area)
(The track width of the construction machines or vehicles to be transported must not exceed the outside frame width of 2,550 mm)
Central storage compartment for wooden planks on loading area
70 mm wooden planks for widening to 3,000 mm
Lashing eyes low-loader
3 pairs of 10 t lashing points integrated in the floor at the front incl.
6 pairs of lashing mushrooms recessed on top and at the side in the outer frame, each 10 t
1 x at the gooseneck
The remaining distributed between, spacing not greater than 1,200 mm
1 x rear bevel
5 pairs of stake pockets integrated into the outer frame, internal 70 x 40 mm (convertible to 5 t ring lashing eyes, not included)
Drawbar assembly trailer turntable
Drawbar with tested 40 mm towing eye
Axles & Suspension
SAF drum-braked axles
Axles/chassis laser aligned to reduce tyre and fuel wear
Parabolic suspension with maintenance-free steel-rubber bearings
Brake system
2-line compressed air brake system
Colour-coded piping for easy service
Spring loaded parking brake
2 interchange-proof coupling heads at the front, with connecting lines to the tractor unit
ABS and ALB, with ABS plug at the front, with connection cable
Podpfx Aaji Ri Ryofjrc
Note: The trailer may only be towed by tractor units which ensure the functionality of ABS!
Wheels and tyres
235 / 75 R 17.5
Manufacturer’s choice
Steel rims in twin arrangement, factory silver
Electrics
24 Volt, multi-chamber lights, side yellow LED illumination
2 white position lights at front
2 white/red track marker lights at rear
2 x 7-pin interchange-proof plugs at front with connecting cable
1 LED beacon with bracket, switched via parking light (removable lamp)
2 pairs of double warning boards, LED-lit and extendable up to 3,000 mm
Floor
Front area steel floor, incl.
Then with 70 mm softwood floor, in wheel arch area steel/chequer plate covering
Rear bevel with 70 mm softwood floor
Low-loader deck incl. rear bevel 8,200 mm
Loading ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally adjustable
Wood-covered
With spring lifting aid
Operating instructions
For 10,000 kg axle load, a special permit is required, only indivisible loads possible!!!
The specified total weight is technically possible; depending on the load, the total weight may not be achievable while complying with permissible axle/kingpin/saddle loads. (Poor driving and tracking behaviour possible due to incorrect load distribution)
Country of registration / Plates
Country of registration: Germany incl.
With Dekra approval and certificate (according to §13 EC - FGV)
24/7 service hotline
Prepared for two-line number pla

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.