Nizki nakladalnik

Fliegl DTL 300 Agrar

Further Information
Chassis Low-bed Trailer
Steel welded construction
Turntable with heavy-duty ball bearing slewing ring
Foldable rear support
2 wheel chocks with holder
Full-width rear mudflap
Preparation for widening to 3,000 mm (holes in outer frame, not in rear bevel)
Low-loader lashing rings
1 pair of lashing cutouts embedded in the front longitudinal beam at the gooseneck, each rated for 10 t
7 pairs of lashing mushroom pins embedded on top and side of the outer frame, each rated for 10 t
1 x on the front gooseneck
5 x in the low-bed area
1 x in the rear bevel
12 pairs of lashing holes in the outer frame, each rated for 5 t (for lashing strap hooks)
5 x at the gooseneck, 6 x in the low-bed area, and 1 x in the rear bevel
Drawbar system for turntable trailer
Bodpfji Ri Agjx Abxeww
Drawbar with certified 40 mm towing eye
Axles & Suspension
Drum brake axles, brand as per manufacturer’s choice
Axles/chassis laser-aligned to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings and mechanical axle load equalization (rocker equalizer)
Wheels and Tires
235 / 75 R 17.5 Fulda
Steel rims in twin arrangement, factory silver
Brake System
2-line air brake system
Spring-loaded parking brake
2 unmistakable coupling heads at the front, with connecting lines to the truck,
Connecting lines extended by approx. 60 cm
No ABS, but with mechanical ALB (automatic load-dependent brake valve), thus maximum 60 km/h permit
Electrics
12 Volt, multi-chamber lights, no side yellow LED lighting, side reflectors
2 white position lights at the front
2 white/red lane marker lights at the rear
1 x 7-pin 12 Volt plug at the front with connecting cable, extended by approx. 60 cm
1 LED beacon with holder, operated via parking light (lamp removable)
2 pairs of illuminated and extendable warning plates up to 3,000 mm
Floor
Front gooseneck with steel/chequer plate covering
Toolbox recessed in the drive-over slant to gooseneck
Following area with 70 mm softwood floor, wheel arch area with steel/chequer plate covering
Rear bevel with 70 mm softwood floor
Low-bed loading area including rear bevel: 5,900 mm
Loading Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Wooden covering
Spring-assisted lifting
Operating Instructions
For axle loads of 10,000 kg, an exemption permit is required; only indivisible loads permitted!!!
The stated total weight is technically possible; depending on the load, the total weight may not be achievable within the allowable axle/support and fifth wheel loads. (Poor driving and trailing behavior possible due to incorrect load distribution)
Country of Registration / Plates
Country of registration: Germany
With Dekra inspection and certificate for max. 60 km/h approval, towing vehicle as agricultural/forestry vehicle (LoF), (for Switzerland, max. 40 km/h possible)
Prepared for double-line license plate holder
No contour markings / reflective tape according to ECE R 048
Painting
Frame: DB 7350 Novagrau
10-year corrosion protection warranty
Drawbar galvanized or black, according to manufacturer’s choice
Loading ramps hot-dip galvanized
Note: Archive images!

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.