Sistem laserskega rezanja

DNE - member of Bystronic group D-Soar Plus 2040 - 12000 Watt

Laser power: 12,000 watts
Working area (laser operation): 4000 x 2000 x 270 mm
Positioning speed X/Y/Z: 200 m/min
Simultaneous: 280 m/min
Max. workpiece weight: 3000 kg
Max. mild steel: 30 mm
Max. stainless steel: 30 mm
Max. aluminium: 25 mm
Max. copper: 10 mm
Max. brass: 20 mm
Length: 12,500 mm
Width: 3,650 mm
Height: 2,620 mm
Machine weight: 18,000 kg

Standard Equipment
Main components
1. Fiber laser source: D-Soar (_CE&UL) / Raycus
2. Cutting head: Bystronic DNE Copyright
3. Cutting software: Hypcut FSCUT 8000C Bus control
4. Gear rack and pinion (X & Y axis): M3 by Herion
5. Shuttle table: Parallel change table (two levels)
Gkedjv Uz Tispfx Ah Doc
6. Ball screw: TBI (Taiwan)
7. Linear guide rail: Won (South Korea)
8. Precision gearbox: Neugart (Germany)
9. Servo drive and motor: Inovance or Schneider
10. Machine bed: Welded machine body
11. PC: I7_CPU 8GB 120GB 10kW
12. Monitor: Capacitive touchscreen (21.5-inch XC-2209CMDR)
13. Proportional valve: Felton low pressure 10kW
14. PLC hardware: Schneider
15. Solenoid valve: High pressure – CEME; Low pressure – Airtac
16. Gantry: Cutting bridge made from aviation aluminum by steel die-casting
17. Chiller: S&A customized
18. Electrical control cabinet: Independent control cabinet (Bystronic DNE Copyright)

Electrical connection (machine including laser source and chiller)
The voltage supplied by the utility provider must meet the requirements of EN 50160 and IEC 60364-1. Stable voltage is essential for constant performance. The power supply must remain stable throughout the permissible network tolerance and must not be affected by surges, such as those caused by spot welding equipment. If such a stable supply cannot be ensured at the installation location, the system must be equipped with a transformer and/or a voltage stabilizer.

Machine power supply, including laser module:
Phases: 3-phase & PE
Supply system: TN
Main frequency: 50/60 Hz
Supply voltage: 3 x 380 V
Max. permissible voltage fluctuation 50 Hz: +/- 10%
Max. permissible voltage fluctuation 60 Hz: +6/-13 %
Fuse: 150 A T
Machine: 22 kW
Hydraulic shuttle table: 15 kW
Exhaust: 7.5 kW
Resonator: 36 kW
Chiller: 15 kW
Power consumption, plant*: 80.5 kW
Power factor cos(φ): 0.83
Average power requirement: 30.75 kW
* Values measured at full laser power and ambient temperature of 20°C; based on average material mix

Compressed air (machine, laser source, cooling unit, extraction unit)
The compressed air must comply with ISO 8573-1:2001. To minimize contamination risk by the compressor, an oil-free screw compressor with downstream air preparation (air dryer) is required.

Min. supply pressure at supply unit: 20 bar
Max. consumption: 1.05 m³/min
Max. inlet air temperature at maintenance unit: 43°C

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.