Avtomatska stružnica

CITIZEN A32-VII (R)

Bar diameter 32 mm
Spindle bore 36 mm
Turning length 320 mm
Spindle speed 200–8000 rpm
Sub-spindle: 32 mm
Turning length 600 mm
Sub-spindle speed: 200–8000 rpm
Rapid traverse speed X1 = 32 m/min
Rapid traverse speed Y1+Z1+X2+Z2 = 45 m/min
Control system Mitsubishi M70
Number of axes: 5+2x C-axis = 7 axes
Operating hours: 119,000 h
Spindle drive: 7.5/5.5 kW
Machine weight approx. 3.5 + FMB t
Required floor space approx. 2.5 x 1.2 x 1.82 plus FMB m
CNC sliding headstock lathe Citizen A32-VII (R) with FMB Turbo 3-36 3200 Var.C bar feeder

Sale due to restructuring.

Machine with 7 axes (X1, Y1, Z1, X2, Z2, C1, C2) in right-hand main spindle configuration, vertical holder for 4 driven turning tools + 3 parting-off tools and + 4 drilling tools. Rear toolholder with 5 stations – see schematic in picture 10. Sub-spindle (pick-off spindle). Simultaneous machining.

The machine has been regularly serviced by Citizen Europe, and wear parts were last replaced in 06/2025. Fire protection system installed in 06/25, bearings and a controller replaced in 06/24.

Equipment:
Collet chuck for main and sub-spindle
Synchronously driven guide bushing
Drive unit for guide bushing
Parts ejector
Cross machining drive unit incl. 4 spindles
Door interlock
Sub-spindle (pick-off spindle)
Partial part basket + conveyor belt
Pneumatic unit for air seal
Internal workspace lighting
Three-color warning light
Parting tool breakage detection
COMBISTREAM high-pressure coolant system with chip conveyor, 8 outlets, 130 bar
4 driven tools for backworking
“Long parts” option 600 mm with parts container, guide tube, and spindle nut
Bar feeder with various material guides (7, 12, 20, 36) adapters, telescopic tubes, and inserts
CO2 fire extinguishing system with FB 703 control, including flame and over-temperature sensor, manual release, and fire event signaling
Stainless steel oil tray beneath the machine

Fgjdpfsxlkwuex Ah Deh
Features of the CINCOM SYSTEM M70PLC CNC control:
• Multi-axis CNC system for simultaneous or single machining
• Tool nose radius compensation
• Cycle repetition
• Deep hole drilling cycle
• Constant cutting speed
• Insertion of chamfers and radii
• Constant cutting speed on sub-spindle
• Thread whirling on the sub-spindle
• Main spindle C-axis
• Sub-spindle C-axis
• Main/sub-spindle synchronization
• Synchronous tapping on main and sub-spindle as well as with driven tools
• Synchronous thread cutting on main and sub-spindle
• Geometric functions
• Collision check
• 8.4" color LCD display

If required, please request the detailed PDF document.

This is a used machine and therefore sold under exclusion of any warranty.

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.