Stroj za toplotno oblikovanje mehurčkov

Uhlmann UPS1030ET

A used and refurbished blister machine, model UPS1030 ET (94/125)

Technical Data
- Format range
Feed width max. 142 x 255 mm
Forming depth max. 10 mm
- Output at least 15 cycles/minute
- Maximum output 70 cycles/minute PVC
- Maximum output 50 cycles/minute ALU

Includes:
- Forming film roll holder with two air shafts, for a maximum roll diameter of 800 mm, electromechanically opening, including cutting and bonding table, painted in neutral grey
- Continuous transport of the forming material with contactless loop control
- Contact heater with 6 individually controlled heating zones (3 zones per plate)
- Forming station prepared for PVC or aluminum forming film with 4-column guide system
- Electrical preparation for pore and crack detection (Visio-Scan)
- Clamping jaw to secure the forming film in the forming station during machine stop
- Servo-controlled feed after the forming station, compensating for film shrinkage
- Contact cooling with servo-controlled feed
- Cooling water connections for upper and lower forming tools and lower sealing tool
- Deflector with compensating pendulum
- Filling section, approx. 1900 mm with angled brush and safety flap
- Electrical preparation for SimTap 2.i and brush-in feed
- Sealing station for plate sealing and toggle lever drive, with 4-column guide (reinforced version with tuning domes)
- Overload protection in the sealing station
- Upper sealing plate automatically retracts during machine stoppage
- Cover foil holder mounted at the rear of the machine with 2 pneumatic expansion shafts, core diameter 76 mm
- Deflection shoulder for cover film with pressure presence control
- Stretching station for cover film with touch-probe controlled stretching (registration mark on the fly)
- Contact cooling station after the sealing station
Nsdpfx Aer Ii R Usb Iedd
- Feed before the punching station
- Embossing station
- Perforating station
- Punching station, adjustable, including blister lowering
- Waste cutter with integrated feed for immediate cutting of the waste grid
- Compressed air monitoring
- Sliding door panels, safety doors electrically interlocked for emergency stop (2-channel), made of plexiglass, lift-up cover in the transfer area
- Electrical cabinet, accessible from the rear of the machine, supply voltage 400/230 Volt, 3/N/PE 50 Hz with neutral and separate earth
The stations have been thoroughly overhauled and obsolete parts replaced during refurbishment.

- Schneider PacDrive3 system with Pac2Touch
- Machine painted in RAL 9007

- Linear transfer system with:
o Lowering unit in the punching station
o Good blister discharge beneath the punch with glide rails
o Single vacuum transfer
o Individual rejection with ejection monitoring
o Collection belt with separate drive
o Transfer belt
o Good blister removal device for subsequent machine stoppage
- CE conformity with declaration of conformity
- Two sets of operator manuals

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.