Upogibni stroj

Placke HQPB 4 60 to. x 1.550 mm

Machine is in like-new condition.

The High Quality Press Brake (HQPB) represents the top model of Placke press brakes. The entire manufacturing process, from hydraulic cylinder to control cabinet construction, is carried out in-house. The combination of state-of-the-art technology and many years of experience in forming technology enables the HQPB series to achieve top-tier bending performance. Even the basic standard version is a fully functional press brake. This package offers safety, reliability, and efficiency, combined with intuitive operation, allowing us to meet the highest demands and precision requirements in the bending process.

Bledpsyvzkiefx Acmjh
Machine Frame:
- Base machine constructed from S 355 N steel
- Side frames welded with two pressure pipes and a top-mounted oil tank
- Above-floor design
- Painted finish (2-component structural paint), light grey (RAL 7035) and signal grey (RAL 7004)

Upper Beam:
- Press beam stress-relieved annealed
- Depth measurement, reading head guided via ball rail system
- Separate Y1 and Y2 control, electrical deflection monitoring

Hydraulic System:
- Hydraulic proportional control valve system with electronically monitored cylinder synchronization
- Solid steel cylinders with inductively hardened piston rods
- Low-noise internal gear pump

Punch Clamping:
- Upper tool holder, WILA system, hydraulic clamping system, type NSCL-II-HC, fully hardened, Max. load: head-supported = 250 t/m, shoulder-supported = 300 t/m

Lower Beam:
- Narrow table incl. manual clamping bar, dimensions: 48 mm high, 70 mm wide
- Reinforced lower beam. Due to the design, the use of mechanical crowning to compensate for deflection is not required.
- Single-V die holder (13x20)
- Working height: 1050 mm (with 55 mm tool height)

Front of the machine:
2 aluminum support arms at the front, approx. 600 mm long, incl. 2 flip stops, tape measure, and plastic wear strip. Support arms are adjustable via a linear ball guide and can be set in height using a slot adjustment from 55 mm to 100 mm tool height. The ball guide is integrated into the lower beam.

Control and Regulation Technology:
- Operating voltage 400V / 3Ph / 50Hz
- Switching and safety components by Telemecanique
- Backgauge with AC servo technology
- Pilz safety PLC

Backgauge "2-axis controlled":
- X and R axes CNC-controlled
- Z axis manual

Delem DA 66 Touch controller mounted on a swing arm.

Safety equipment according to CE standard

Technical data and working area:
Press force 600 kN
Working length 1550 mm
Space between uprights 1200 mm
Installation height 400 mm
Throat depth 255 mm
Ram stroke 215 mm

Ram speeds:
Rapid traverse max. 280 mm/s
Pressing speed max. 9.8 mm/s
Return speed max. 170 mm/s
Ram positioning accuracy ± 0.01 mm
Ram tilt ± 10 mm
Electronically limited to ± 5 mm
Height of lower beam above floor 947 mm
Motor power 5.5 kW

Main dimensions:
Depth below floor 0 mm
Side frame pit depth 0 mm
Machine weight approx. 6.5 t
Tank capacity (hydraulic oil) 120 l

(Technical specifications subject to change)

Rear machine lighting:
Work area illuminated by LED light strip between the uprights.

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.