Stroj za upogibanje pločevine - 4 valji

MG MH 2010 B

Sheet width 2050 mm
Sheet thickness 10.0 mm steel
Pre-bending 8.0 mm steel
Top roller diameter approx. 220 mm
Side roller diameter approx. 170 mm
Lower roller diameter approx. 190 mm
Bending speed approx. 2.0 + 5.0 m/min
Control system ELAP LYNX
Oil capacity 80.0 liters
Voltage 380 V
Total power requirement 5.5 kW
Weight 5000 kg
Dimensions L-W-H 3500 x 1550 x 1400 mm
Very good condition (!!)
Current new price incl. accessories approx. EUR 90,000
Fgjdpfxoxaah Es Ah Djh
Special price on request

Equipment:
- Robust electro-hydraulic 4-roll plate bending machine
- 4-roll design enables a wide range of bending and rounding options
- MG NC control unit "ELAP LYNX"
* Operation – control of all rollers or machine axes
* Digital position display
* Manual operation via joysticks
* Freely movable control panel
- Two central rollers driven directly by hydraulic motors
- Conical bending possible via roller tilting
- Side roller parallelism via torsion shafts
- Pre-bending on both sides
- Diameters up to 1.1 times the top roller diameter possible
- Forged and hardened rolls with a strength of 53–55 HRC
- Low-maintenance, stable machine design
- Continuous lubrication of all bearings
- Sturdy welded steel construction
- 2 selectable bending speeds
- Electro-hydraulic swing-arm bearing for easy pipe removal
- Manometer / pressure gauge for the rollers
- Safety device (safety cable with switch unit)
- Operating manual (PDF)

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.