Drugo

Fliegl ZPS 200 K Jumbo Z

Further Information

Chassis
Turntable Chassis for Waste Management
Fine-grain steel welded construction

Container locking:
- 2 pairs of locking hooks recessed into the floor
- Pneumatic operation

The container locking system is a 2-point version, acting from the inside; locking of roll-off containers with an internal web is not possible (for transporting roll-off containers with subframes according to DIN 30722).

Note! At the beginning of the roller recess at the front, the container must be slid on completely flat!

Longitudinal guide rails laterally adjustable and removable, rails approx. 115 mm high

Turntable with heavy-duty ball bearing slewing ring

8 pairs of lashing mushroom fittings recessed into the upper and side outer frame, each with 5 t capacity

7 pairs of stake pockets recessed in the outer frame, inside 70 x 40 mm (convertible to 5 t ring lashing eyes, not included in delivery)

2 wheel chocks with holders

Side underrun protection in aluminum

Rear underrun protection in steel

Quarter-shell mudguards according to EC standard

With anti-spray mudflaps according to EC standard

Drawbar equipment - Turntable trailer
Towing bar with tested 40 mm towing eye

Axles & Suspension
SAF drum brake axles
Axles/chassis laser-aligned – reduces tire wear and fuel consumption
Parabolic spring suspension with maintenance-free steel-rubber bushings

Wheels and Tyres
235 / 75 R 17.5
Manufacturer’s choice
Steel twin rims, factory silver

Braking System
2-line compressed air brake system
Spring chamber parking brake
2 polarity-proof coupling heads at the front, with connecting lines to the towing vehicle
ABS and ALB, with ABS plug at the front, with connection cable

Attention: The trailer may only be towed by vehicles that ensure the effectiveness of the ABS!

Electrical Equipment
24 volt, multi-chamber lights, side yellow LED lighting
2 white position lights at the front
2 white/red lane marker lights at the rear
2 x 7-pin polarity-proof plugs at the front, with connection cable

Floor
Steel floor
Roller recess for container at the front recessed in the floor, for roll-off containers from 5,000–7,000 mm length

Note: Slight floor undulation due to welding distortion is possible!

Ramps
Lockable storage compartment for ramps beneath the loading platform

Operating Notes
At 10,000 kg axle load, a special permit is required. This permit must be applied for separately in each federal state; the legislature is not required to guarantee approval for a 20-ton GWV. Customer’s risk.

The specified total weight is technically possible; depending on the cargo, the total weight may not be achievable while complying with permissible axle, support, and kingpin loads. (Poor driving and tracking behavior possible due to incorrect load distribution)

Country of Registration / Plates
Country of Registration: Germany
With Dekra inspection and certificate (according to §13 EC - FGV)
Iodpfxsi Ri Nuj Ah Dobc
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips according to ECE R 048, white on sides and red at rear
Warning plate according to ECE - 70

Paintwork
Frame DB 7350 Nova grey
15-year warranty against rust-through

Note: Floor undulation possible due to hot-dip galvanizing!

Drawbar KTL black

Attention: Archive images!

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.