Odprta platforma

Fliegl TPS 200 Jumbo Z

Additional Information
Chassis Central Axle Trailer
Fine-grain steel welded construction
Type TPS 200 (special permit required)
Gear support leg at the front
Foldable rear support
Wheel chocks with holder
Aluminium side underrun protection
Full-width rear mudflap
Mudflaps in front of each axle and anti-spray mudflaps behind each axle
1x spare wheel holder for 1 E-wheel, with wheel fixing kit
1x spare wheel, same brand as main tyres, steel rim
1x stainless steel toolbox, width=600 / height=400 / depth=500 mm, with polished door, lockable
Lashing eyes on low loader
5 pairs of stake pockets recessed in the outer frame, inside 70 x 40 mm (can be converted to 5 t ring lashing eyes, not included)
7 pairs of lashing mushrooms recessed in the top and side of the outer frame, each rated at 10 t
2 additional pairs of folding lashing eyes recessed in the low bed area, each 10 t – 1 pair at the front and 1 pair at rear incline
Central axle trailer drawbar assembly
Drawbar with tested 50 mm towing eye
Axles and Suspension
SAF drum brake axles
Axle/chassis laser alignment reduces tyre and fuel consumption
Axle spacing 1810 mm (with 10 t axle load technical rating)
Tsdep N Dguepfx Ab Ssd
Air suspension
Brake system
2-line compressed air brake system, color-coded lines for easy servicing
Spring-loaded parking brake
Duomatic coupling at the front with connection to truck
EBS, Electronic Braking System with EBS connector at the front and connecting cable
Note: This trailer may only be towed by vehicles that ensure correct ABS function!
With lift and lower valve
Vehicle driving stability system
Axle load detection via EBS CAN bus signal for display in driver’s cab – truck must be pre-equipped accordingly, not for trucks not fitted (not a calibrated scale)
Wheels and Tyres
235/75 R17.5 make Fulda
Steel rims, factory silver
Electrics
24 Volt, multi-chamber lights, lateral yellow LED marker lights
2 white position lamps at front
2 white/red track marker lamps at rear
1 x 15-pin connector at front with connection cable
1 additional LED work lamp at rear, switched with reverse light
1x LED beacon with bracket, switched with parking light (removable lamp)
Floor
Then fitted with 70 mm softwood floor, steel/chequer plate covering in wheel arch area
Rear incline with Mega Grip anti-slip grating
Low-bed area including rear incline 6500 mm
Front bulkhead / corner posts
25 mm aluminium box section, 400 mm high, removable
Ramps
Steel ramps 3600 mm long, 750 mm wide, split and tensioned with cable pull, laterally adjustable
Ramp adjustment, minimum spacing approx. 600 mm, maximum outer width approx. 2880 mm
Ramp surface with Mega Grip anti-slip grating
Hydraulic operation via dedicated electro-hydraulic unit mounted in a steel box, controls on right-hand side. Note: NATO socket with connection cable required on truck. Connection cable must not be attached while driving!
Hydraulic lateral adjustment of ramps, individually controllable (only in combination with hydraulic ramp operation)
Operating Instructions
The specified gross weight is technically possible, but depending on the cargo the maximum gross weight may not be achievable while adhering to permitted axle, support and kingpin loads. (Incorrect load distribution may cause poor driving and tracking behavior)
A special permit is required for 10,000 kg axle load. The permit must be applied for individually in each federal state; there is no guaranteed legal right to approval for 20 t gross weight. Customer assumes risk.

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.